彩鋼板的應用還需要滿足各種條件。只有在施工過程中注意這些細節，才能更好地發揮產品的作用。更多
濟南彩鋼板的相關內容將由我們的工作人員為您解釋：
The application of color steel plate also needs to meet various conditions. Only by paying attention to these details in the construction process can we better play the role of the product. More relevant contents of Jinan color steel plate will be explained to you by our staff:
1.盡量避免在陽光直射和灰塵飛揚的情況下施工彩鋼板。
1. Try to avoid the construction of color steel plate under direct sunlight and flying dust.
2.嚴禁在潮濕表面涂漆；露點溫度取決于環境相對濕度和空氣溫度的組合。
2. It is forbidden to paint on wet surfaces; The dew point temperature depends on the combination of ambient relative humidity and air temperature.
3.工作環境應清潔、干燥、通風。環境溫度5℃以上，相對濕度85%以下，方可施工。如果超過任何限制，應立即采取措施，否則不得施工。
3. The working environment should be clean, dry and ventilated. The construction can only be started when the ambient temperature is above 5 ℃ and the relative humidity is below 85%. If any limit is exceeded, immediate measures shall be taken, otherwise construction shall not be carried out.
4.避免在強風中工作；在炎熱天氣下工作時，應避免冷卻氣流的影響。如果在這種環境下工作，只能使用刷涂，并做好防塵工作。
4. Avoid working in strong wind; When working in hot weather, avoid the influence of cooling airflow. If you work in this environment, you can only use brush painting and do a good job of dust prevention.
5.彩鋼板室外施工時，遇雨、霧、露或表面可能潮濕時，應停止施工。
5. During the outdoor construction of color steel plate, the construction shall be stopped in case of rain, fog, dew or the surface may be wet.
此外在安裝彩鋼板時應注意：
In addition, pay attention to the following when installing color steel plate:
1.安裝彩鋼板固定件，并用自攻螺釘將固定件固定在檁條上，自攻螺釘安裝在每根檁條上。
1. Install the color steel plate fastener, and fix the fastener on the purlin with self-tapping screws, and install the self-tapping screws on each purlin.
2.在固定件上放置一塊鋼板，與各固定件的肋底槽和內肋壓緊，并完全嚙合。
2. Place a steel plate on the fastener, press it tightly with the bottom groove of the central rib and the inner rib of each fastener, and fully mesh.
3.鋼管×3M腳手架搭設2根4m長管道，每根腳手架設4個輪子，便于推進。
3. Steel pipe × Two 4m long pipes shall be set up on 3M scaffold, and four wheels shall be set up on each scaffold to facilitate propulsion.
4.先安裝車頂內層板。根據技術要求，每個波峰用30mm長的專用自攻螺釘固定，螺帽顏色與彩鋼板顏色一致。
4. Install the inner roof panel first. According to the technical requirements, each wave crest is fixed with a 30mm long special tapping screw, and the color of the nut is consistent with that of the color steel plate.
5.用彩鋼板鋪設保溫棉，保溫棉接縫用專用膠帶密封。
5. Pave insulation cotton with color steel plate, and seal the joint of insulation cotton with special tape.
The color steel products produced by our company are light in weight and convenient in transportation. They can be used in suburban and urban areas. The utility model has beautiful appearance, bright color and cost saving. Buy when you need it http://m.yunhu3.com Come on!
