When installing the color steel composite board, the construction shall be carried out according to the correct construction sequence. In addition, some construction points need to be noted:

　　一、處理彩鋼復合板時，一定要用干凈的手套去觸摸鋼板，不要拉其它東西在粗糙的表面或鋼板上。

　　1、 When handling the color steel composite board, be sure to touch the steel plate with clean gloves, and do not pull other things on the rough surface or steel plate.

　　其次，在安裝彩鋼板時，一定要拉線，以確保所安裝的彩鋼板邊緣應在同一條線上，尤其是在安裝塊彩鋼板時，一定要雙向測試，并在調整后，才能鎖定。每安裝六個左右的極板，就需要對其進行測試，并隨時進行調整，以避免累積偏差。

　　Secondly, when installing the color steel plate, it is necessary to pull a line to ensure that the edge of the color steel plate installed should be on the same line, especially when installing the first color steel plate, it is necessary to test it in two directions and lock it after adjustment. Every six or so plates are installed, they need to be tested and adjusted at any time to avoid accumulated deviation.

　　使用的工具必須是特殊的工具。

　　The tools used must be special.

　　彩鋼復合板作為一種常用的輕質建材產品，其施工質量一直以來都有嚴格的要求，所以在安裝施工時一定要注意主要的細節問題，避免后期施工帶來的麻煩。

　　As a kind of commonly used lightweight building materials, the construction quality of color steel composite board has always been strictly required, so it is necessary to pay attention to the main details during the installation and construction to avoid the trouble caused by the later construction.

　　以上是濟南彩鋼生產廠家為大家介紹的相關內容，想要了解更多內容，歡迎訪問網站：http://m.yunhu3.com

　　The above content is introduced by Jinan color steel manufacturer. If you want to know more, please visit the website: http://m.yunhu3.com